Amiga Accelerator Cards Guide

Classic Motorola 68020/030/040/060 cards (Blizzard, Apollo, A3640) vs. modern TerribleFire, Furia 600, ACA series, and PiStorm (Emu68 vs Musashi).

1. Classic Motorola Accelerators (68020 / 68030 / 68040 / 68060)

Original 1990s Phase5 Blizzard, CyberStorm, Apollo, Commodore, and GVP CPU cards.

68020 & 68030 — The WHDLoad Sweet Spot

  • Phase5 Blizzard 1230 Mk IV (A1200): Full 50 MHz MC68030RC50 with MMU, optional 68882 FPU, 72-pin SIMM socket (up to 64 MB 60ns EDO/FPM, or 128 MB with the SCSI-IV kit), MapROM jumper, and zero motherboard timing quirks.
  • 68020 Cards (Blizzard 1220/4, Hawk, M-Tec): 14–28 MHz 68EC020 with 4–8 MB Fast RAM; budget WHDLoad entry point, though 8 MB cards seated in the 24-bit Zorro II window ($200000–$9FFFFF) on A600/A1200 can conflict with PCMCIA if above 4 MB.
  • Big-Box 030s (A2630, GVP G-Force 030, Blizzard 2060): Add 32-bit local Fast RAM outside the 8 MB Zorro II ceiling, bypassing the 7 MHz motherboard bus entirely.

68040 & 68060 — High-End Workstation & Demo Power

  • Commodore A3640 (A3000/A4000): 25 MHz 68040 CPU card; notorious for three backwards-mounted SMD electrolytic caps (C105, C106, C107) from factory silkscreen errors — always check polarity and upgrade to Rev 3.2 state-machine GALs.
  • Phase5 Blizzard 1260 / CyberStorm MkII & PPC / Apollo 1240-1260: 50–66 MHz MC68060 (Rev 1, Rev 5, or flagship Rev 6 mask 71E41J capable of 80–100 MHz).
  • 3.3 V Voltage Regulator & Dummy Library Rule: The 68060 is a 3.3 V processor requiring an onboard step-down regulator from +5 V. Kickstart expects LIBS:68040.library — you must install Phase5's small dummy 68040.library (~700 bytes) that redirects to 68060.library, or use Thor's MMULib package.

2. Modern Open-Source & Commercial Accelerators

TerribleFire (ehide.device), Furia 600, Individual Computers ACA series, and PiStorm (Emu68 vs Musashi).

TerribleFire Series (TF536, TF1230, TF1260)

  • TF536 (A500 / A500+ / A2000): 50 MHz 68030 + 64 MB 32-bit Zorro III Fast RAM + onboard 44-pin buffered IDE. Fits the 68000 socket via a relocator board.
  • TF1230 (A1200): 50 MHz 68030 + 64 MB Fast RAM + fast IDE header in the A1200 trapdoor slot.
  • TF1260 (A1200): 50–100 MHz 68060 (software-switchable clock via cpuspeed) + 128 MB Fast RAM + fast IDE.
  • Setting up ehide.device: TerribleFire's CPLD IDE controller is NOT mapped to Gayle's $DA0000 register space — it uses ehide.device. Either burn a custom Kickstart 3.1/3.2 ROM containing ehide.device, or boot from the motherboard IDE and run LoadModule DEVS:ehide.device REVERSE NOREBOOT in S:Startup-Sequence.

Furia 600 & Individual Computers ACA Series

  • Furia EC020 (A600): Clips over the soldered 68000 PLCC-68 (clean PLCC leads with IPA first and bolt down with nylon standoffs!). Gives 33 MHz 68EC020 + 68882 FPU + 9.5 MB Fast RAM. Press Ctrl+Amiga+Amiga for 3 seconds to toggle 4 MB PCMCIA-friendly mode via furiatune.
  • ACA500plus (A500/A500+): Plugs into the 86-pin left side expansion slot; 14–42 MHz 68SEC000, 8 MB Fast RAM, dual Boot/Data CF slots (hot-swappable FAT95 data slot), built-in Action Replay, and Kickstart 1.2/1.3/3.1 Flash ROM switcher.
  • ACA1221lc / ACA1233n / ACA1234 (A1200 & ACA500plus): 25–50 MHz 68020/68030 cards with 16–128 MB Fast RAM, MapROM, and ACAtune speed/cache control.

PiStorm & PiStorm32-Lite (Emu68 vs Musashi)

  • Hardware Variants: Classic PiStorm (A500/A2000 DIP-64 socket, or A600 PLCC adapter) uses a Raspberry Pi 3A+, 3B+, or Zero 2W. PiStorm32-Lite (A1200 150-pin trapdoor edge) uses a Raspberry Pi 3A+, 4B, or CM4.
  • Emu68 (Bare-Metal ARM JIT — Recommended): Boots in <2 seconds directly into an ARMv8 bare-metal 68040 JIT translator (500–1100+ MIPS), provides up to 256–512 MB Fast RAM, brcm-sdhc.device high-speed SD card partitioning (25+ MB/s), and native 1080p RTG graphics via VideoCore.card (Picasso96) over the Pi's HDMI port.
  • Musashi (Linux-Hosted Interpreter): Runs Raspberry Pi OS Linux in the background with an interpreted 68020/030/040 core (~40–80 MIPS). Slower boot (~15s) and requires clean shutdowns, but supports Wi-Fi network bridging (a314/pi-net) and mounting Linux folders as Amiga drives.

A1200 Motherboard Timing Fixes for Accelerators

  • Rev 1D4 & Rev 2B Boards: Commodore's factory notes specify removing SMD ferrite/capacitor pairs E123C & E125C (and checking E121C/E122C) on the underside of the PCB near the 68EC020 to clean up CPUCLK and E-clock skew with ACA, Blizzard, Apollo, and TF1260 cards.
  • WHDLoad Tooltypes for 030/040/060/Emu68: If an older OCS game crashes or runs too fast on a 68040/060 or PiStorm, add NOCACHE, NOMMU, or NoVBRMove to the icon's Tooltypes.

Accelerator Comparison Matrix

Card / PlatformTarget AmigaCPU & ClockFast RAMStorage / RTG ExtrasPSU +5V Add
Blizzard 1230 Mk IVA120068030 @ 50 MHz + MMUUp to 64/128 MB SIMMOptional SCSI-IV kit+0.6 A
Blizzard / Apollo 1260A120068060 @ 50–80 MHz32–128 MB SIMM3.3V VRM; needs 68060.library+1.1 A
TerribleFire TF536A500 / A200068030 @ 50 MHz64 MB Zorro III44-pin IDE (ehide.device)+0.6 A
TerribleFire TF1230 / TF1260A120068030 (50MHz) / 68060 (50-100MHz)64 MB / 128 MB44-pin IDE (ehide.device)+0.6–1.2 A
Furia EC020 Rev 2/3A60068EC020 @ 33 MHz + 688829.5 MB (4MB PCMCIA toggle)IDE speedup via furiatune+0.5 A
ACA500plusA500 / A500+68SEC000 @ 14–42 MHz8 MB + 1MB Chip remapDual CF slots + KS ROM switcher+0.5 A
PiStorm / PiStorm32-LiteA500/A600/A1200/A2000ARM JIT 68040 (Emu68)256–512 MBHDMI RTG (P96) + 25MB/s microSD+0.9–1.4 A

Theme Palette

Default Dark
High-contrast dark
Amber Terminal
Monochrome amber
Matrix CRT
Phosphor green
Workbench Light
Clean light mode

Audio & Display

Relay Click Sounds Web Audio API — soft mechanical clicks
CRT Scanline & Flicker Pure CSS overlay effect

System Info

Customization Panel Theme preference, audio FX, and CRT overlay settings are saved to your browser's localStorage and persist between visits. No cookies or server-side storage is used.
Keyboard Shortcuts Press Esc to close this panel. Use the header moon/sun icon to cycle themes.