Amiga Diagnostics
Guru Meditation decoder, boot-colour explorer, CIA isolation guides, and interactive fault-flowcharts for every Amiga.
Guru Meditation Decoder
Paste the left hex field (e.g. 80000003) to decode severity, subsystem and error.
Exception Codes (byte 2)
80000002Bus Error ·80000003Address Error — RAM/expansion80000004Illegal Instruction ·80000008Privilege — ROM/code8000000BLine-1111 trap — often CIA/timing80000019–1FInterrupt levels — CIA-B IRQ storms
Subsystem Digit (2nd hex)
068000/task crash ·1RAM subsystem2ROM/Kickstart ·3Custom chips4CIA / I-O · leading8= recoverable,0= dead-end
Boot Screen Colour Explorer
Click the colour your Amiga shows — Red=ROM, Green=Chip RAM, Yellow=CPU, Blue=custom chips.
8520 CIA Isolation — Step by Step
CIA-A (Even, U7) — Keyboard/Parallel/OVL
- Verify pin 20 = +5 V, pin 34 /RES released, pin 25 E-clock ~0.7 MHz.
- Keyboard dead + no LED blink: probe SP/CNT (pins 39/40) while pressing keys.
- Floppy-step test: CIA-A also owns /OVL — a stuck overlay shows dark-grey screen.
CIA-B (Odd, U8) — Floppy/Serial/Ports
- No motor/seek: /MTR (pin 17) must drop on boot seek; /SEL0 (pin 16) low when DF0 active.
- /STEP (pin 10) pulses during seeks; serial dead → check /PC (18), /FLAG (24) and ±12 V driver rails.
- Prove it: power off, swap U7↔U8 — a fault that follows the chip confirms the CIA.
Complete Diagnostic Flowchart: Amiga Boot Screen Colour Failure Isolation (Commodore Amiga 500/500+/600/1200 (OCS/ECS/AGA))
STEP 1: Power On with RGB Connected - Does the Screen Show RED?
[node-1]
Connect the Amiga via RGB/SCART or composite, power on, and watch the background colour sequence for ~30 seconds. Choose YES if the screen flashes or stays RED.
Expected Reading: Dark grey -> light grey -> white -> Workbench hand = healthy. Any solid colour = hardware fault.
STEP 2: Does the Screen Turn GREEN?
[node-2]
A steady GREEN screen means the Kickstart Chip RAM test failed. On A500: reseat Fat Agnus (U2, PLCC-84) and remove the A501 trapdoor card. On A1200: inspect Chip RAM SIMM pads and DRA0-DRA9 vias.
Expected Reading: Green = Chip RAM or its address/data path (Agnus/Alice, DRA/DRD lines, /RAS//CAS).
STEP 3: Does the Screen Turn YELLOW?
[node-3]
YELLOW means the 68000 took an exception (bus/address error, illegal instruction) before handlers were installed. Check the 68000 socket, Kickstart ROM seating, Gary /DTACK and /BERR lines, and any accelerator card.
Expected Reading: Yellow = CPU exception - usually ROM, CPU socket, Gary or expansion bus, not RAM.
STEP 4: Does the Screen Turn BLUE or CYAN-Flashing?
[node-4]
BLUE indicates a custom-chip register fault (Agnus/Denise/Paula or Lisa/Alice). Cyan/light-blue flicker points at the CIAs or keyboard. Reseat Agnus/Denise/Paula if socketed; check the 8520 CIAs and E-clock (~0.7 MHz at pin 25).
Expected Reading: Blue = custom chip register write failure. Cyan flicker = CIA/keyboard fault.
STEP 5: Dark Grey, Light Grey-Only, or WHITE Screen?
[node-5]
Dark grey that never advances = CPU runs but Kickstart not mapped (check CIA-A /OVL, Gary /ROME, ROM socket). White/grey that stalls = normal wait for a slow IDE/SCSI device on A600/A1200/A3000 - disconnect drives and retest.
Expected Reading: Dark grey = no ROM fetch (overlay/ROM/Gary). Long white = storage timeout or Gayle IDE fault.
[ISOLATED FAULT: RES-RED-ROM] RED Screen - Kickstart ROM or ROM Path Failure
VERDICT
The POST checksum or ROM fetch failed. Suspect the Kickstart ROM, its socket, Gary /ROME (pin 21) or the address path to U6.
[ISOLATED FAULT: RES-GREEN-CHIPRAM] GREEN Screen - Chip RAM or Agnus/Alice Failure
VERDICT
Kickstart RAM test failed on the first 512K-2MB of Chip RAM, or Agnus/Alice cannot generate valid /RAS//CAS.
[ISOLATED FAULT: RES-YELLOW-CPU] YELLOW Screen - 68000 Exception (Bus/Address Error)
VERDICT
The CPU took an exception early in POST: bad ROM code, /BERR or /DTACK held, or an expansion card driving the bus.
[ISOLATED FAULT: RES-BLUE-CUSTOM] BLUE / CYAN Screen - Custom Chip or CIA Failure
VERDICT
Register writes to Agnus/Denise/Paula (or Lisa/Alice) failed, or the CIA subsystem did not respond to POST.
[ISOLATED FAULT: RES-GREY-ROM] Dark Grey / Long White - ROM Overlay or Storage Timeout
VERDICT
Dark grey = Kickstart never mapped at $000000 (CIA-A /OVL, Gary /ROME, ROM). White stall = A600/A1200 waiting on a dead IDE device.
[ISOLATED FAULT: RES-PROGRESS] Screen Advances Normally - Check Drives & Peripherals
VERDICT
POST colours cycled correctly; the fault is downstream - floppy, IDE, PCMCIA, mouse ports, or PSU under load.